Wireshark · Wireshark-users: Re: [Wireshark-users] Adding DSCP column in Wireshark 1.4.0rc1

["Keith French" <keithfrench@xxxxxxxxxxxxx>]

That is a bit better, but the columns now show the hex value, not decimal, 
as it did in V1.2.x where the filter used to be:-

ip.dscp.value

The problem seems to have crept in since the filter syntax was changed to:-

ip.dsfield.dscp

Keith French.

--------------------------------------------------
From: "Stig Bjørlykke" <stig@xxxxxxxxxxxxx>
Sent: Wednesday, June 30, 2010 1:59 PM
To: "Community support list for Wireshark" <wireshark-users@xxxxxxxxxxxxx>
Subject: Re: [Wireshark-users] Adding DSCP column in Wireshark 1.4.0rc1

> On Wed, Jun 30, 2010 at 2:45 PM, Keith French <keithfrench@xxxxxxxxxxxxx> 
> wrote:
> > I have just tried the development release Version 1.5.0-SVN-33383 and 
> > that
> > is still the same as 1.4.0rc1, the columns for DSCP & 802.1P COS are 
> > still
> > resolved & hence show the full verbose setting for each packet under the
> > column headers. It would be far more useful if this could be unresolved,
> > showing just the decimal value.
>
> Did you try unselect "Show Resolved" in the column pop-up menu?
>
>
> --
> Stig Bjørlykke
> ___________________________________________________________________________
> Sent via:    Wireshark-users mailing list <wireshark-users@xxxxxxxxxxxxx>
> Archives:    http://www.wireshark.org/lists/wireshark-users
> Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
>
> mailto:wireshark-users-request@xxxxxxxxxxxxx?subject=unsubscribe