Hi
I am unable to get the output of Rawshark.
I have a packet structure as below when decoded with Wireshark.
|
Ethernet II |
|
802.1Q VLAN |
|
IP |
When I execute the following I am getting following error:
$ rawshark –d encap:105 –r packet-name –F ip.src -s
0 FT_IPv4 BASE_NONE -
rawshark: "packet-name" is neither an interface nor a pipe
How to use the rawshark to get the output of Source IP address in the packet?
Can anyone help me?
Regards,
Atdev
Please do not print this email unless it is absolutely necessary.
The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy all copies of this message and any attachments.
WARNING: Computer viruses can be transmitted via email. The recipient should check this email and any attachments for the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email.
www.wipro.com
