Wireshark · Wireshark-dev: [Wireshark-dev] plugin_if: plugin_if_goto_frame not changing packet detail

[Paul Offord <Paul.Offord@xxxxxxxxxxxx>]

Hi,

I've written a small TCP service that runs on a thread inside Wireshark. I use Putty to send a frame number to the service which then uses plugin_if_goto_frame to command Wireshark to jump to the frame number sent. It works fine except for one problem.

Although the correct frame is highlighted in the Packet List, the Packet Detail and Packet Bytes don't change to match the new frame number. I've recorded a short video of this which you can see at https://youtu.be/jUHuC_2rTcM

What do I need to do to get Wireshark to update the Packet Detail and Packet Bytes?

Thanks and regards...Paul

 

______________________________________________________________________

This message contains confidential information and is intended only for the individual named. If you are not the named addressee you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system.

Any views or opinions expressed are solely those of the author and do not necessarily represent those of Advance Seven Ltd. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. The sender therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission.

Advance Seven Ltd. Registered in England & Wales numbered 2373877 at Endeavour House, Coopers End Lane, Stansted, Essex CM24 1SJ

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please visit http://www.symanteccloud.com
______________________________________________________________________