Wireshark-dev: Re: [Wireshark-dev] q: why does ./tools/randpkt-test.sh uses a bash array for TS
I believe you are looking at the output after tshark has been run twice, once with each set of arguments. When it runs with the first set of args, you will see:
Pass 1:
arp: (-nVxr)
... and when it runs with the second set of args, you will see:
Pass 1:
arp: (-nVxr) (-nr)
After that completes, you'll see:
Pass 1:
arp: (-nVxr) (-nr) OK
... and then on to the next one:
Pass 1:
arp: (-nVxr) (-nr) OK
bgp: (-nVxr)
etc.
-----Original Message-----
From: wireshark-dev-bounces@xxxxxxxxxxxxx [mailto:wireshark-dev-bounces@xxxxxxxxxxxxx] On Behalf Of Toralf Förster
Sent: Wednesday, November 27, 2013 3:24 PM
To: Developer support list for Wireshark
Subject: [Wireshark-dev] q: why does ./tools/randpkt-test.sh uses a bash array for TSHARK_ARGS
From what I can see there's just 1 call of tshark with all args at once, or ? And the output proves it too :
(pls Cc: me directly)
tfoerste@n22 ~ $ cd ~/devel/wireshark/; nice ./tools/randpkt-test.sh Running ./tshark with args: "-nVxr" "-nr" (forever) Running ./randpkt with args: -b 2000 -c 5000
Pass 1:
arp: (-nVxr) (-nr) OK
bgp: (-nVxr) (-nr) OK
bvlc: (-nVxr) (-nr) OK
dns: (-nVxr) (-nr) OK
--
CONFIDENTIALITY NOTICE: The information contained in this email message is intended only for use of the intended recipient. If the reader of this message is not the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. If you have received this communication in error, please immediately delete it from your system and notify the sender by replying to this email. Thank you.
