I digged in bit further and found where the SIGSEV is signaled. Its coming from the p_stats(). Here is what i got in gdb
[New Thread 0xb78acb70 (LWP 3668)]
Program received signal SIGSEGV, Segmentation fault.
[Switching to Thread 0xb78acb70 (LWP 3668)]
0x00f6f433 in pcap_stats () from /usr/lib/libpcap.so.0.8
looks like the seg-fault if thrown by libpcap.
Has anyone else experianced the similar thing while using Wireshark 1.6.5 (im running it in Ubuntu on VirtualBox)?
I got this when i start wireshark from the command line through:
./wireshark -k -i /tmp/pipeIt waits for any input from the pipe and when i did "cat capturefile.pcap > /tmp/pipe", wireshark displayed the contents partially (97 pckts out of 110)
and crashed with
Segmentation fault.
On Fri, Mar 2, 2012 at 7:33 PM, vijay
<vijay.prasanth@xxxxxxxxx> wrote:
Hi,
I start wireshark from command line : "sudo ./wireshark -k -i /tmp/pipe"
I have a capture dump in libpcap format which i wite into the pipe (/tmp/pipe) after starting wireshark. Everytime i do this wireshark
displays the contents of the file but at the end it shows segmentation fault. The capture file is from my previous run of wireshark saved in libpcap format.
Wireshark perfectly works with the same file when open though GUI. I am using wireshark 1.6.5 on linux. Could some one pls tell me
why this behavior occurs?
Thanks
Vijay
