Hi,
Thank you for the advice, it was very helpful...
Regards
Ankith
On Mon, Jul 11, 2011, Jaap Keuter <jaap.keuter@xxxxxxxxx> said:
> Hi,
>
> You could take a look at the CDP dissector:
> http://anonsvn.wireshark.org/wireshark/trunk/epan/dissectors/packet-cdp.c
>
> It has basically the same problem, which it solves by re-using the ett
> value.
>
> Thanks,
> jaap
>
> On Mon, 11 Jul 2011 14:22:51 +0530 (IST), Ankith Agarwal wrote:
>
>> Hi
>> I am writing a plugin for dissection of MIH protocol.
>> https://bugs.wireshark.org/bugzilla/attachment.cgi?id=6547
>> This protocol contains all the information in form of TLVs(type
>> length
>> value), also this protocol does not specify the maximum number of
>> TLVs
>> inside a packet. I am confused in the display of the TLVs. I tried it
>> with
>> assigning a subtree to each TLV, is there any better way of doing it?
>> -> Also, in the plugin I have set the number of TLV subtrees to 20,
>> but
>> that is not a good way of doing it, can someone also tell me how to
>> set
>> variable length subtrees in ett array.
>>
>> Regards
>> Ankith
>
>
> ___________________________________________________________________________
> Sent via: Wireshark-dev mailing list <wireshark-dev@xxxxxxxxxxxxx>
> Archives: http://www.wireshark.org/lists/wireshark-dev
> Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev
> mailto:wireshark-dev-request@xxxxxxxxxxxxx?subject=unsubscribe
>
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
>
--
WARM REGARDS
Ankith Agarwal
Project Engineer
CDAC Hyderabad
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
