|
Hi Mahendran,
I can reproduce your issue when I disable "Allow
subdissector to reassemble TCP streams". When I have that setting enabled,
packet 47,51 and 55 show up fine.
Can you check that setting in the TCP protocol
preferences and enable it if it was disabled (as I would expect, based on your
findings).
Cheers,
Sake
----- Original Message -----
Sent: Tuesday, December 23, 2008 7:51
PM
Subject: [Wireshark-dev] Parsing SMB
Packet
Hi,
I am using Wire Shark 1.0.5.
I am trying to
capture the SMB packets using Wire Shark. It parses the SMB Request correctly
but unable to parse the SBM Response that is sent from our device. The content
are shown under "Continuation Data". If it parses properly that will help me
in analyzing the packets. Could you please help me?
I have attached the
capture for your analysis. Look at the packet no 47, 51 and 55.
Best
Regards,
Mahendran
___________________________________________________________________________
Sent
via: Wireshark-dev mailing list
<wireshark-dev@xxxxxxxxxxxxx>
Archives:
http://www.wireshark.org/lists/wireshark-dev
Unsubscribe:
https://wireshark.org/mailman/options/wireshark-dev
mailto:wireshark-dev-request@xxxxxxxxxxxxx?subject=unsubscribe
|
