Thanks and sorry for the typos.
The MIBS preferences are not available until libsmi is installed. The
libsmi requirement was found several references away from any immediate
discussion or user configuration documentation for SNMP.
-----Original Message-----
From: Luis EG Ontanon [mailto:luis@xxxxxxxxxxx]
Sent: Friday, February 08, 2008 3:07 PM
To: Developer support list for Wireshark
Subject: Re: [Wireshark-dev] 0.99.7 SNMP v2 Config?
Look for "MIBS" in the Protocols tree of the preferences.
On Feb 8, 2008 8:27 PM, Donaldson Charles-MGI1064
<charlesdonaldson@xxxxxxxxxxxx> wrote:
> I do not see the MIP preference page. As in not MIB preference to
> select.
>
>
> -----Original Message-----
> From: Jaap Keuter [mailto:jaap.keuter@xxxxxxxxx]
> Sent: Thursday, February 07, 2008 1:16 PM
> To: Developer support list for Wireshark
> Subject: Re: [Wireshark-dev] 0.99.7 SNMP v2 Config?
>
> Hi,
>
> In 0.99.7 this can be entered through the MIBS protocol preference
page.
> Since then it has moved to the more logical name resolution page, but
> that has to wait until 0.99.8 is released.
>
> Thanx,
> Jaap
>
>
> Donaldson Charles-MGI1064 wrote:
> > I post a question to the users list and received no response.
> >
> > How is SNMP v2 configured in 0.99.7. The MIB entry field is no
> > longer available. And the doc's only discuss configuring v3 engine
options.
> >
> > Where do the MIBs go?
> > How do you specify the MIB location?
> > How do you specify the MIB load sequence?
> >
> >
> >
> > Regards,
> > Charles Donaldson
> > charlesdonaldson@xxxxxxxxxxxx <mailto:charlesdonaldson@xxxxxxxxxxxx>
> >
>
>
> _______________________________________________
> Wireshark-dev mailing list
> Wireshark-dev@xxxxxxxxxxxxx
> http://www.wireshark.org/mailman/listinfo/wireshark-dev
>
--
This information is top security. When you have read it, destroy
yourself.
-- Marshall McLuhan
