Wireshark-dev: Re: [Wireshark-dev] Can't see my protocol in "Decode As ..." menu
Date Index · Thread Index · Other Months · All Mailing Lists
Date Prev · Date Next · Thread Prev · Thread Next
From: "Anders Broman" <anders.broman@xxxxxxxxxxxx>
Date: Tue, 22 Jan 2008 18:32:34 +0100
Hi,
How are your dissectors registered?
dissector_add("udp.port",...)?

If your packets are recognised as RTP you may wish to register the
dissectors with the RTP dissector (see packet-h264.c).
Regards
Anders 

-----Original Message-----
From: wireshark-dev-bounces@xxxxxxxxxxxxx
[mailto:wireshark-dev-bounces@xxxxxxxxxxxxx] On Behalf Of Glenn Shirley
Sent: den 22 januari 2008 10:31
To: wireshark-dev@xxxxxxxxxxxxx
Subject: [Wireshark-dev] Can't see my protocol in "Decode As ..." menu

Hi all,

I'm currently building Wireshark on CentOs 4 and trying to add in my own
protocols.  

My build appears fine but when I run my newly built version of Wireshark
I can see my protocols in the "Analyze | Enabled protocols" list but
they aren't visible under the "Decode as" menu.

My build on Win32 runs fine.

These protocols are really just different RTP payloads.  

Is there something special that has to be done on Linux compared to
Win32?
Any hints as to where to start looking appreciated!

Regards,
Glenn.

No virus found in this outgoing message.
Checked by AVG Free Edition. 
Version: 7.5.516 / Virus Database: 269.19.8/1236 - Release Date:
21/01/2008
8:23 PM
 

_______________________________________________
Wireshark-dev mailing list
Wireshark-dev@xxxxxxxxxxxxx
http://www.wireshark.org/mailman/listinfo/wireshark-dev