Wireshark-dev: Re: [Wireshark-dev] Where is libpcap-devel source code.
John wrote:
Near as I can tell, my Solaris 10 x86 system needs libpcap-devel,
compiled from source, in order for wireshark to build:
No, it needs a development version of libpcap to build versions of
Wireshark *OR* TShark that can capture packets. It can build versions
of TShark *AND* Wireshark without libpcap, but those versions would only
be able to read and dissect existing capture files - they wouldn't be
able to capture traffic.
It needs GTK+ to build Wireshark, but it doesn't need it to build TShark.
Use pcap library : yes
It appears to have found libpcap.
I cannot seem to find the source code for "libpcap-devel", only the RPM?
If you found an RPM, you might be looking in the wrong place, unless
people are packaging up source for non-Linux systems in RPMs. The
source code for libpcap can be downloaded from
http://www.tcpdump.org/
and if you build and install it, you get the header files and libraries
you need to build programs with libpcap. (There's no "libpcap-devel" on
www.tcpdump.org - the split between "libpcap" and "libpcap-devel" is a
characteristic of binary packages for libpcap, so that if you want to
run programs that use a libpcap shared library, but don't need to build
programs that use libpcap, you can just install "libpcap" without also
installing "libpcap-devel".)
However, as it appears you already have libpcap - complete with the
header files, so you have the development stuff installed - so don't
spend any more time worrying about libpcap.
Instead, worry about GTK+:
Additional "configure" information, which may, or may not(?) be helpful:
checking for GTK+ - version >= 2.0.0... no
*** Could not run GTK+ test program, checking why...
*** The test program failed to compile or link. See the file config.log
for the
*** exact error that occured. This usually means GTK+ is incorrectly
installed.
It's *very* helpful - it shows that the problem is that the configure
script couldn't find GTK+.
What does the file "config.log" say about GTK+? That file should be in
the top-level source directory for Wireshark.
