Wireshark-bugs: [Wireshark-bugs] [Bug 9516] Error while installing wireshark-1.10.3 from RPM bui
Comment # 11
on bug 9516
from vishnu.bhatt@aricent.com
(In reply to comment #10)
> (In reply to comment #9)
> > Filesystem 1K-blocks Used Available Use% Mounted on
> > 10.118.213.156:/home/vishnu.bhatt
> > 300648216 201159640 83970184 71% /home1/vishnu.bhatt
>
> OK, that's NFS, and you can't set capability bits over NFS, as NFS has no
> notion of capability bits for files.
>
> I don't know what the right way is to construct a package that sets
> capabilities on files if possible and doesn't give errors if it can't.
>
> And part of the problem here is that Wireshark *will behave differently*
> depending on whether the capabilities are set on dumpcap or not - it will be
> able to capture without special privileges if they're set, but won't be able
> to capture with special privileges if they're not.
>
> I would try doing "make distclean" and then configuring with
> --disable-setcap-install and --enable-setuid-install and building Wireshark
> and the RPM; that might get rid of the setting of the capabilities and,
> instead, make dumpcap set-UID, which is the best you can do with an
> NFS-mounted file system.
>
> Try that and see whether it works. If not, we might have to make the "build
> the RPM" steps pay attention to those two configuration flags.
Actually I always did the same thing and earlier also NFS was there but this
error never came. Can you please paste the actual ./configure flags which I
need to give.
Is this ok?
./configure --enable-setuid-install --disable-setcap-install
You are receiving this mail because:
- You are watching all bug changes.
