Wireshark-bugs: [Wireshark-bugs] [Bug 6184] S1AP dissector COL_INFO should display different mes
https://bugs.wireshark.org/bugzilla/show_bug.cgi?id=6184
--- Comment #4 from billyjeans@xxxxxxxxx 2011-08-16 17:43:52 PDT ---
(In reply to comment #3)
> (In reply to comment #2)
> > Created an attachment (id=6800)
--> (https://bugs.wireshark.org/bugzilla/attachment.cgi?id=6800) [details]
[details]
> > s1setup
> >
> > Only id-S1Setup is displayed at the INFO column, however we can not tell that
> > the 1st msg is S1SetupRequest, the 2nd is S1SetupResponse unless open the
> > message detail.
> > There are many such cases like:
>
> If you right-click on the S1AP-PDU item in the protocol details pane and
> choose, "Apply As Column", does that work for you? When I did that, I got a
> column titled, "S1AP-PDU" with values of "initiatingMessage" for the 1st packet
> and "successfulOutcome" for the 2nd packet.
>
> In general, you can apply most fields as a column, so if this particular field
> isn't enough information for you, then you might try adding it along with other
> field(s).
This works in some cases. However there are multiple status in handover
scenarios, this trick only show either initialingMessage or successOutcome
which is not preferred. I generate a patch for s1ap.cnf and it seems works for
me.
--
Configure bugmail: https://bugs.wireshark.org/bugzilla/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are watching all bug changes.
