|
I have a Dell 3024 switch, so I hope the answer isn't going
to be that much off target.
When I log onto the switch, one of the choices I have at
the main menu is 'Port Mirroring'.
When I select that menu, I am asked to enter the
'source port' and the 'monitor port'.
I believe for your answer the 'source port' would be to
identify port 5 and the monitor port is 11.
Mirroring is a toggle on/off choice using the spacebar when
that choice is selected.
Hope this works for your model of switch also.
Craig Wicker
Systems Administrator
p:276.638.3020
440
E. Commonwealth Blvd
Hooker Furniture Corporation
Martinsville, VA
24112
www.hookerfurniture.com
Sniffer Certified Professional
CompTIA
A+, N+
Microsoft MCP
Cisco CCNA
HP-UX
Be careful what you ask
for;
you just might get it.
Hi all,
I set up the port monitor for dell
switch 3324, destination port 1/e11, source port 1/e5. I run ethereal on
destination port 1/e11 and select Ethernet interface for capture (interfaces
of source port 1/e5 not appeared) but I did not receive any
packets from source port 1/e5. I read through the documentation & FAQ and
I did not find any answer. I need help. Any one has this problem before? And
if I capture traffic on destination port I will receive all packets from
destination and source ports at the same time?
Thanks in
advance
Regards,
Lien
Do
| 
