Ethereal-users: [Ethereal-users] RECALL - Linux 7.3 - PCMCIA Cisco 350 ap and Ethereal

Note: This archive is from the project's previous web site, ethereal.com. This list is no longer active.

Date Index Thread Index Other Months All Mailing Lists
Date Prev Date Next Thread Prev Thread Next
From: Ian Johnson <ian.johnson@xxxxxxxxxxxxxxxxx>
Date: Tue, 5 Nov 2002 17:25:35 +1100 
Sorry for any inconvenience, I have resolved the problem, I had two
interfaces with the same name.

Ian Johnson

> -----Original Message-----
> From:	Ian Johnson 
> Sent:	Tuesday, 5 November 2002 4:49 PM
> To:	'ethereal-users@xxxxxxxxxxxx'
> Subject:	Linux 7.3 - PCMCIA Cisco 350 ap and Ethereal
> 
> Hi,
> 
> I need some help in configuring Ethereal/Linux to run on my Compaq laptop.
> 
> Linux 7.3 has recognised the card, a Cisco PCMCIA 350 series ap, I have
> installed the Cisco drivers and the Cisco ACU software and all this has
> worked well and I can associate to nodes.
> 
> However I want to run Ethereal, I have installed the RPM's, I can start
> the program but I cannot see the interface which should be eth2 which is
> what was designated during the Cisco driver install.
> 
> I have tried in user and root mode with no luck, I think that I need to
> tell Linux about the device but I am not sure how.
> 
> any help or direction appreciated, thanks
> 
> Ian Johnson
>