On lun, aoû 02, 1999 at 03:42:55 -0700, Guy Harris wrote:
> > Perhaps, but if my memory is not too bad, I think I had to configure
> > the modulo value for my network before capturing with a radcom
> > analyser, so I suppose it can't be guessed.
>
> Perhaps, if an SABME frame must be in the capture file, you have to
> configure it in the analyzer to handle the case where you *don't*
> capture the SABME frame.
Yes.
> Can the RADCOM analyzer read a capture file it's saved? If so, do you
> have to configure the modulo value even if you're reading a saved
> capture?
No. That's why I think the modulo value is saved in the capture file.
I will verify if my sniffer also asks for this configuration (I can't
check now, I'll have to wait until after my hollidays...)
> > I have a sniffer that handles X.25, and the manual says nothing
> > about it.
>
> Oh, well. It doesn't have *any* section in the manual about the
> capture file format?
Yes, but there's nothing X.25 specific in it (I had to guess where the
"From DCE/From DTE" information was stored).
Olivier
--
Advice to young men: Be ascetic, and if you can't be ascetic,
then at least be aseptic.
